Re: 1982 Johnson 35 Tiller Conversion and other questions
That's it. A little dirty, but looks to be intact, and it has the throttle rod and gear, so you should be able to just clean it up and install it. Good luck on the auction!<br /><br />One piece of advice I just thought of (this may not make sense until you go to do it)...when you are removing the old steering bracket, there is a nut in the front of the pivot shaft that you will have to remove (it's way up in there under the front edge of the steering bracket). There is a flat washer under that nut that you will have to remove also. It may be hard to see, but make sure you remove it. I did not see the washer on there and pulled the unit apart without removing it...it shot off at mach 2.
That's it. A little dirty, but looks to be intact, and it has the throttle rod and gear, so you should be able to just clean it up and install it. Good luck on the auction!<br /><br />One piece of advice I just thought of (this may not make sense until you go to do it)...when you are removing the old steering bracket, there is a nut in the front of the pivot shaft that you will have to remove (it's way up in there under the front edge of the steering bracket). There is a flat washer under that nut that you will have to remove also. It may be hard to see, but make sure you remove it. I did not see the washer on there and pulled the unit apart without removing it...it shot off at mach 2.
