Hi everyone,
I'm hoping someone can point me in the right direction.
I have a 1982 Starcraft Questar 191 with a Volvo Penta AQ140. Recently I've been having an issue where the engine won't restart after running for a while.
I took the boat to a marine repair shop for diagnosis. They went through the electrical system and found that some of the cables become extremely hot after the engine has been running. They disconnected the alternator and the gauge/instrument wiring during testing but were unable to isolate the problem.
The only consistent issue they found was that the battery voltage drops from about 12.7V down to around 8V (or even lower) when attempting to start the engine.
Unfortunately, the shop eventually gave up and couldn't determine the cause.
Has anyone experienced something similar with an AQ140 or older Volvo Penta setup? Could this be a bad starter motor, a ground issue, high resistance in the battery cables, a faulty solenoid, or something else entirely?
Where would you start troubleshooting?
Any advice is greatly appreciated. Thanks!
I'm hoping someone can point me in the right direction.
I have a 1982 Starcraft Questar 191 with a Volvo Penta AQ140. Recently I've been having an issue where the engine won't restart after running for a while.
I took the boat to a marine repair shop for diagnosis. They went through the electrical system and found that some of the cables become extremely hot after the engine has been running. They disconnected the alternator and the gauge/instrument wiring during testing but were unable to isolate the problem.
The only consistent issue they found was that the battery voltage drops from about 12.7V down to around 8V (or even lower) when attempting to start the engine.
Unfortunately, the shop eventually gave up and couldn't determine the cause.
Has anyone experienced something similar with an AQ140 or older Volvo Penta setup? Could this be a bad starter motor, a ground issue, high resistance in the battery cables, a faulty solenoid, or something else entirely?
Where would you start troubleshooting?
Any advice is greatly appreciated. Thanks!