ab59
Ensign
Thread starter- Joined
- May 10, 2017
- Messages
- 992
Hello everyone, it's been a while I know but life gets in the way sometimes. I changed the impeller on my little 90 hp tower of power the other day, and when putting the lower back on, it will not shift out of forward gear. What I did from the start. Not my first time replacing an impeller on this motor. I put the forward lever all the way forward, engaging forward gear. I Pulled the lower, installed a new water pump and impeller, mounted the lower back on the motor and it won't shift out of forward gear. I lowered the unit an inch or two. I then took an 11/32 inch wrench and turned the shift spline at the lower all the way to the right and re aligned everything and pulled it back into position, making sure everything lined up. Again still in forward no matter were I put the gear selector at. I have repeated this process no less than 8 times because everything I can find on this procedure says that this will correct the problem. But it does not!!!!! I just can't figure it out. What say those of you who know???? thanks----