1987 Black Max 150 water pressure gauge

[Deadeye53]

I am attempting to install a water pressure gauge on this motor. Information indicates removing brass plug on right side and adding the brass fitting. I find no brass plug on the side? There is one on the left side just below thermostat, wired for a temperature gauge. Where is the proper installation point?

 

[Dukedog]

on top of tha block, right behind tha flywheel you will se a 3/4" "pipe plug".. thats where it goes.. you will need ta adapt down in size to match a 90* fitting for your gauge... ace hardware is good place for fittings.. usually lots better selection ta match whatcha gonna need...

 

[achris]

#19...

 

[Deadeye53]

Thank you!!!..