I have picked up a new project.
1988 25HP Evinrude E25RCCA
The guy I bought it from said he cleaned carb, fuel pump replaced, and new water pump.
This is pull start. I pull it and get nothing. On 3rd or so pull it backfires and seems a bit harder to pull but still no start tho.
I saw the link and sync was way off. I adjusted that, I am not too familiar with this year. I adjusted according to a older model. Lowest throttle position, got the cam roller set right before the 2 marks on armature plate. Turn throttle and cam hits and starts to open carb right in the middle of the marks. Test and still no start.
I read a thread from racerone talking about the link from the carb to back of motor and this collar needs to be set correctly. I am unsure of where it should be and bet guy adjusted this.
Attached are pics. Let me know if I need better pics. Thanks for any advice.
1988 25HP Evinrude E25RCCA
The guy I bought it from said he cleaned carb, fuel pump replaced, and new water pump.
This is pull start. I pull it and get nothing. On 3rd or so pull it backfires and seems a bit harder to pull but still no start tho.
I saw the link and sync was way off. I adjusted that, I am not too familiar with this year. I adjusted according to a older model. Lowest throttle position, got the cam roller set right before the 2 marks on armature plate. Turn throttle and cam hits and starts to open carb right in the middle of the marks. Test and still no start.
I read a thread from racerone talking about the link from the carb to back of motor and this collar needs to be set correctly. I am unsure of where it should be and bet guy adjusted this.
Attached are pics. Let me know if I need better pics. Thanks for any advice.
