1988 Alumacraft Phantom V170

[mistertwister87]

Does anyone have a wiring schematic for this particular boat? I have tried contacting Alumacraft, but was told they do not keep those records for boats this old. I am trying to re-wire the bow panel up front, specifically the run/charge switch and the voltage gauge (reads up to 18 volt). I have a 12/24 volt motorguide trolling motor (12/24 switch on the foot pedal) and I think I know how to re-wire that setup. The previous owner cut the orange wire on the backside of the receptacle to just allow this to be a 12 volt trolling motor. :facepalm:


Can anyone give me any advise on how to incorporate the run/charge switch (if I even need to use this) and the voltage gauge? Do I need to swap this gauge out for a 24 volt gauge?


Thanks and your help is much appreciated!