1989 25hp Evinrude compression release

sorville

Cadet
Joined
Jul 18, 2013
Messages
6
Hi, 120# compression each cylinder. motor spins freely without plugs, with the spark plugs installed the motor does not want to turn over with the starter maybe 2 compression strokes, and by hand about the same. The motor is in netural during these tests.Is there a compression release on this motor?
 

racerone

Supreme Mariner
Joined
Dec 28, 2013
Messages
38,677
Charge the battery.----Load test the battery.----Take starter apart for inspection.----Check battery cables.
 

sorville

Cadet
Joined
Jul 18, 2013
Messages
6
Charge the battery.----Load test the battery.----Take starter apart for inspection.----Check battery cables.
I used a car battery which is fully charged, trying to start by hand is real difficult maybe 2 revolutions and I'm pulling real hard it don't seem normal
 

airshot

Vice Admiral
Joined
Jul 22, 2008
Messages
5,540
Fully charged is 12.7 volts...12 volts is dead. Squirt some storage oil in the cylinders and crank it over a bit to lube thing up and see what happens. Check for corroded connections !!
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,174
Does that have a recoil starter on it. Those motors are pretty stout to pull. Check all your electrical connections. Make sure they are shiny clean the grounds on the block also.
 

sorville

Cadet
Joined
Jul 18, 2013
Messages
6
Thanks for the input, it was in the wiring bad ground, the motor purrs like a kitten
 
Top