Re: 198x 200 Oil Injected Black Max
Make sure if you go pre-mix that you get the plastic "dummy" drive shaft, and the metal screw plug. The screw plug needs to be screwed in where the line comeing from the main oil tank screws in the lower part of your motor. Disconnect the line and insert the screw plug. The dummy shaft will go where the old drive shaft went, it will fit over the hole where your oil pump used to be. It will also hold the gear in place so it no longer spins. Throw the old pump away! Disconnect all old oil lines, and alarm wires(they are the wires going to the pump, unscrew the harnes at the pump and cut the wires) and discard them also. Make sure you pre-mix now 50-1. It may smoke a bit more at slow speeds but it will run fine, and no more worries. You can get these two parts from your local marine for about 20 bones.<br />Good luck and let us know.<br />CU<br /><br />--------------------<br />RUNNING THE MOTOR WHILE LISTENING TO THE HORN WILL MAKE YOU MORN!!
