rustybeater
Seaman Apprentice
- Joined
- Jun 26, 2011
- Messages
- 48
OK i am going to be honest the tilt and trim were working fine and i had just performed a rebuild on the motor. I was installing the power head and one of the last thing to do was splice the trim switch back in on the side out the outboard housing. While I was splicing the wires (red, blue and green) some of the wires touched and it trimmed up a little. I did not really think much of it but when I was done the trim is not working at all I am wondering if any one has any ideas on what I may have messed up? I have never done any work on the tilt/trim system before