1FASTLASER
Petty Officer 2nd Class
- Joined
- Dec 8, 2006
- Messages
- 158
Got a couple of questions. First on the install of a tack........the boat and motor never had one. Am I to move both of the yellow/grey wires down on the power strip to the grey wire on the power strip to get the tack running.
Second question is I have installed a water psi gauge after almost cooking the motor but thankful only blew head gasket. replaced all needed parts...impellar t stats head gaskets and exhaust cover gasket and water pump hosing. Motor pissing very good but I dont like the hookup of the psi gauge, I have heard that you are better off tapping into the top of the block. I looked at the sticky on the psi gauge install but it dont look like my motor. Does someone have a pic that better illustrates where I need to tap into for the psi gauge. Right now I just t'd off of my tell tale and I sure dont like what I am getting for readings.
Second question is I have installed a water psi gauge after almost cooking the motor but thankful only blew head gasket. replaced all needed parts...impellar t stats head gaskets and exhaust cover gasket and water pump hosing. Motor pissing very good but I dont like the hookup of the psi gauge, I have heard that you are better off tapping into the top of the block. I looked at the sticky on the psi gauge install but it dont look like my motor. Does someone have a pic that better illustrates where I need to tap into for the psi gauge. Right now I just t'd off of my tell tale and I sure dont like what I am getting for readings.
