I was wanting to know how to check my priming solenoid. I have voltage going to the solenoid and the correct ohms when the solenoid is off. How can I check to see if the thing is working. I cant get my motor started and I have tried depressing the key for 5-8 seconds and I hear no clicking or anything. I have to turn the little red lever to get it started and while I am in gear at slow speeds run back there and flip the lever back to the run postition. It runs good after that until I go to start it again and I have to do the same thing. Also at WOT it runs great but every once in a while it will mis like it is starving for fuel...could this be a float issue. If so how do I check the float to make sure it is set right? I can not seem to get this thing running right. Cleaned tank, new fuel lines, new plugs etc. Help please!!!
