1997 Fast Strike 115

[Jacob645]

Found a better deal on an amazingly well-kept boat. Tell me what you know about this motors pros and cons. Lower Unit is only 3 years old. Thanks guys!

 

[tashasdaddy]

Re: 1997 Fast Strike 115

good motor, if maintained properly.

 

[Jacob645]

Re: 1997 Fast Strike 115

Thanks TD. This one looks like a better deal than the FICHT anyway! It'll definitely be a step up from my 1975 Evinrude 50hp even though she's still running strong!

 

[SparkieBoat]

Re: 1997 Fast Strike 115

yes go with this one over the fitch....but if you can find a 4-stroke you will save big $$ on fuel,..also a much quieter motor..depends on how much fuel you burn in a year on if its worth it or not.

 

[pmillar]

Re: 1997 Fast Strike 115

Are there any specific maintenance areas that should be looked at closely? (I have the same engine, fwiw)

 

[SparkieBoat]

Re: 1997 Fast Strike 115

compression, and general condition of motor, including lack of corrosion, clean gear case oil. 3 things I look for right off

 

[jonesg]

Re: 1997 Fast Strike 115

If over 10 yrs old, start at the tank, replumb everything, install water seperator. New clamps, double clamp fill hose and ground the steel wire insert to the tank and fill nozzle.

Compression test and write numbers in your manual.
www.outboardbooks.com

Replace fuel filter on engine.
Rebuild carbs,
water pump,
t'stats,
clean all grounds (remove coils and re-install),
gear oil (use new seals),
remove prop and check for fishing line on shaft - lube shaft.
Plugs and wires.

 

[pmillar]

Re: 1997 Fast Strike 115

Excellent list, thanks (on behalf of Jacob645 )

 

[bob johnson]

Re: 1997 Fast Strike 115

what is the specific feature of the FAST STRIKE model , that is different than an ocean runner model of ther same hp and year? both appear to be the 60 degree looper motor, also known as an EAGLE block according to a mechanic I met.

thanks

bob

 

[pmillar]

Re: 1997 Fast Strike 115

I think the Faststrike has a 500 rpm higher rev limit. If so, I'm not sure how it is accomplished - whether it's just the ignition or if there's anything mechanically altered to deal with the added stresses.