200hp OptiMax 2007 no spark

[snapperman-nz]

I have a 200hp jet drive optimax with no spark, When connected to the mercury DDT and a automatic diagnostic test is done the spark is there, Thats with the motor not running and the plugs out for a visual inspection. With the stop circuit disconnected and the motor cranking there is still no spark,
The battery is fully charged
lanyard checked
fuses checked
To me it looks like the PCM (control module may be faulty or crank position sensor)

Can anyone help with this ??

Thanks
Snapperman

 

[snapperman-nz]

Re: 200hp OptiMax 2007 no spark

Hi there, still chasing answers, can anyone help

 

[CharlieB]

Re: 200hp OptiMax 2007 no spark

Ignition System:
–Check for proper operation by using Inductive Timing Light 91-99379.
–Check battery voltage (RED/YEL Lead) @ ignition coils.
– Check for blown fuse (C15).
– Check battery voltage to fuse from key switch (PURPLE Lead).
–Check for shorted stop wire (BLK/YEL).
–Check crank position sensor setting [0.015 in. – 0.040 in. (0.38mm – 1.01mm)] from flywheel
or for defective crank position sensor.
–Defective ECM. Power Supply: Clean and inspect remote control male and female harness connectors.