Greendiver
Petty Officer 3rd Class
- Joined
- Aug 16, 2009
- Messages
- 99
After hanging out for a bit, I've decided to jump in and start a thread to track the journey of getting this Mariner back in the water.
This is going to be my new best friend, I'm sure...
A photo of the bow....
...and the stern.
Here is the way the windshield was mounted prior to being disassembled by the PO. I would like to lift the windshield about 10-12" to allow for more protection if I can get it to look ok and not crazy out of proportion.
Wait a minute, windshield? Well when I bought this boat I didn't realize that the Mariner was a center console boat. I just thought it was very similar to the SS but a little plainer. One of the PO's must have added the walk through at some point. If I'm off in the woods, please educate me!
Oh well, off to tighten hull rivets and shop for Gluvit, and buy more rivets.

This is going to be my new best friend, I'm sure...

A photo of the bow....

...and the stern.

Here is the way the windshield was mounted prior to being disassembled by the PO. I would like to lift the windshield about 10-12" to allow for more protection if I can get it to look ok and not crazy out of proportion.

Wait a minute, windshield? Well when I bought this boat I didn't realize that the Mariner was a center console boat. I just thought it was very similar to the SS but a little plainer. One of the PO's must have added the walk through at some point. If I'm off in the woods, please educate me!
Oh well, off to tighten hull rivets and shop for Gluvit, and buy more rivets.
Last edited: