22 year old DP-SM advice

stouchton

Petty Officer 3rd Class
Thread starter
Joined
Feb 12, 2018
Messages
96
My outdrives (2) are 22 years old and have never been rebuilt. I did replace boots 8 years ago - my universals could not be greased so I saw no reason to pull them off periodically after that. Even my gimbal bearings are original. For personal reasons I just ran the boat to escape life (wife was terminally ill).

Last season I heard a bearing rumble while in gear on the port outdrive. I did find a tiny amount of water in it end of this season. So figured I have a bad bearing/race in that outdrive. Starboard has no issues. I will be bringing both drives home tomorrow.

Question 1: I will be rebuilding the port outdrive (I have done many car differentials, so I understand what I am getting in to here). Should I rebuild the starboard also or simply just reseal due to age?

Questions 2: My cone clutches work fine. How do you know when to replace them?

Question 3: None of my bearing/race pullers/drivers are long enough to work so I will need to source the VP tools. Is there a source for used or alternatives? I scoured the auction site and found nothing.

Last question (for now...): Is there a cross reference somewhere on the web from VP part numbers to Timken/SKF? I did not find much searching the web.

I appreciate any insight and help you might have.
 

Scott Danforth

Grumpy Vintage Moderator still playing with boats
Staff member
Joined
Jul 23, 2011
Messages
53,426
Get a FACTORY manual

Most likely the bellows let water in and the input shaft seal and bearing is all that is needed

Do a pressure test and a vacuum test
 

Kosmofreeze

Petty Officer 3rd Class
Joined
Aug 23, 2023
Messages
86
Curious to know how many hours your 22 year old DP-SMs have accumulated? My 25 yo DP-SM just clicked over 400 hrs (yeah, I know ... it's just broken in!) this past season. I average about 30 hrs per year. The boat is fresh water only and "lives" on a trailer. I'm wondering how the effects of time compare with the effects of in-service hours on these drives. I replaced the bellows a couple years ago ... the old ones still looked brand new. The log book suggests the gimbal bearing was replaced in 2011 at 200 hours. Can these "gently used" drives last another 20-30 years? Where's the best place to spend your preventative maintenance $$$ on these things?
 
Top