3 wire to 2 wire tilt conversion ??

[Huntnfish08]

I've got 1995 75hp 2 stroke. SN 0g1xxxx. Has solenoid tilt control. I pulled those, and replaced with relay system from a 2001 75hp.
So far all good. But I have 2 extra wires I need help identifying and where they go in the new setup.
2 red wires were connected to the lower solenoid headed toward the bow. They go behind the oil tank and then I don't know where.
What are they for and where do I connect them on the relay system?
Thanks

 

[Huntnfish08]

I'm thinking just hook them up to the starter solenoid as that's where they technically drew power from before? Via a jumper from starting solenoid to tilt solenoids.