FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
You will first need to remove the powerhead, drop the lower unit and inspect the pump. Sounds like alot of work but it is really not. You will likely need an impeller, especially if it has been a couple years. If the impeller housing is scored or damaged, replace it. Same goes for the impeller plate. Grooves or scoring will cause air pockets in the pump causing an overheat. In the water pump kit you will also get an o ring for the top of the driveshaft, be sure to replace this and re grease the splines of the shaft with marine grease. Replace the grommets at either end of the water line, and be sure not to pinch them when installing. Ill post a link that may help. Let us know if you need any help. Good luck.
