65 merc sitting

[old heap]

well it was sitting for a few years not winterized so how do i go about trying to get thing started? any tips on this thing or maybe a howto write up

i think the gas will need drained carb cleaned and new plugs

 

[ENSIGN]

Re: 65 merc sitting

You're going to have to at least rebuild the carbs and replace the impeller,but first spray a little fogging oil in the cylinders,crank it over and then hook up the muffs and see if the old girl will start.

 

[old heap]

Re: 65 merc sitting

impeller same as propeller? if not can i get a pic gimme a car i know it but boats are new

 

[ENSIGN]

Re: 65 merc sitting

The impeller is the water pump and is located on the top of the lower gearcase. You should do a search here on i boats and get the service manuel for your motor. Did you get it to start ???

 

[Fuzzytbay]

Re: 65 merc sitting

Read here: http://www.maxrules.com/timingindex.html
Just pick out your motor from the menu.
Also in the RnM FAQ's is a thread on how to properly awake a sleeping outboard.

 

[old heap]

Re: 65 merc sitting

didnt try ran out of light it looks like onthe side theres two things with high pressure lines going to them what are they? their lines are cracked should i replace?
i took the case off the top and it looks rough but salvageable lol ill get pics next chance
thanks guys

 

[Fuzzytbay]

Re: 65 merc sitting

didnt try ran out of light it looks like onthe side theres two things with high pressure lines going to them what are they? their lines are cracked should i replace?
i took the case off the top and it looks rough but salvageable lol ill get pics next chance
thanks guys

Black lines, behind the fuel lines, going on to the block? or on the distributor side going to the cap, and front of the cowl?

 

[old heap]

Re: 65 merc sitting

block lines with high pressure ends on them like small hydrolic hoses

 

[Fuzzytbay]

Re: 65 merc sitting

Those lines are for lubricating the bearings, if they are cracked they must be replaced. You most likely can't get the actual hose's anymore, and will have to make your own. I think any fuel grade line of the correct diameter will work.

 

[emckelvy]

Re: 65 merc sitting

Check the Engine FAQ for good info on topics such as "Awakening a sleeping outboard" and carb rebuilding:

http://forums.iboats.com/forumdisplay.php?f=31