pgcountry10
Recruit
- Joined
- Oct 22, 2009
- Messages
- 4
I have a 1979 merc 260, The trouble is the the tilt/trim its a one solnoid, 2 switch set up. It goes up no problem but will not go down, The pump runs in when you hit the down switch but no response from the drive. I recently found that the wires to the trim limit and sender switches were both rotted away so i bypassed the limit switch for now. The sender wires i did nothing with yet, would that have anything to do with it?
The drive is stuck in the up position so i cant really get a accurate reading on the fluid level, but just looking in the fill hole i can see fluid. i have took the vent scew all the way out and still no change. I was thinking about going to the cylinders next to check for pressure there. The cylinders have 2 lines and they both go in the bottom. Any help in the right direction would be much appreciated. Thanks -Mark-
The drive is stuck in the up position so i cant really get a accurate reading on the fluid level, but just looking in the fill hole i can see fluid. i have took the vent scew all the way out and still no change. I was thinking about going to the cylinders next to check for pressure there. The cylinders have 2 lines and they both go in the bottom. Any help in the right direction would be much appreciated. Thanks -Mark-
