88 HP Evinrude SPL questions

tomandwendy

Seaman Apprentice
Thread starter
Joined
Mar 31, 2008
Messages
31
I was wondering if anyone knew if this engine had a trim switch located on the engine or the back of the boat?? I have not been able to see one because I do quite a bit of fishing alone and getting the engine up and down with the metal engine holder is quite a task. Do I need to install a switch?
 

tashasdaddy

Honorary Moderator Emeritus
Joined
Nov 11, 2005
Messages
51,019
Re: 88 HP Evinrude SPL questions

it should have a switch on the remote control handle. if it has trim and tilt. you can add a switch at the stern, if the motor has trim and tilt. trim and tilt was an option on that motor.
 

tomandwendy

Seaman Apprentice
Thread starter
Joined
Mar 31, 2008
Messages
31
Re: 88 HP Evinrude SPL questions

Thanks for the response, but I am new to boating and this boat, but I am not able to locate the romote tilt switch........it is a trim and tilt engine though....but only way to operate is from my throttle
 

tashasdaddy

Honorary Moderator Emeritus
Joined
Nov 11, 2005
Messages
51,019
Re: 88 HP Evinrude SPL questions

from the throttle/shift handle at the remote control, correct. that is all they came with. not one on the motor, or rear of the boat. you can add a switch to the rear of the boat. there is a special way of wiring it so both switches work. which i am not familiar with.
 

Dhadley

Supreme Mariner
Joined
Feb 4, 2001
Messages
16,978
Re: 88 HP Evinrude SPL questions

If your motor has TnT what is the "metal engine holder" you refer to? On a motor with trim & tilt, tilting it manually is - as you mention - quite a task. Even with the manual release screw open.

If it has TnT there should be a cover over a hole for the switch on the lower motor cover (pan the hood sits on), dependoing on what year it is. If not, you can simply drill a hole. There is a switch kit you can get and it's a real simple plug & play deal. No big deal at all really.
 

Bushleaguer

Seaman
Joined
Jun 10, 2002
Messages
56
Re: 88 HP Evinrude SPL questions

My '97 115 SPL has a switch on the throttle, and one on the starboard side of the engine itself, near where the throttle cables enter the motor. It is a factory switch- it came that way when I bought it.
 

black pearl

Recruit
Joined
May 2, 2009
Messages
4
Re: 88 HP Evinrude SPL questions

my 96 88spl has tilt trim switch on controls and on motor starboard side below cowling
 
Top