90 Evinrude 115 powerpack

[DavidD]

Has anyone ever seen a powerpack that would only send power to 3 out of 4 coils? Every bad pack I have ever noticed wouldnt fire any of the coils.

 

[Bob_VT]

Re: 90 Evinrude 115 powerpack

Could be the sensor assy or the powerpack. Have you used the CDI troubleshooting guide? Technical Support | CDI Electronics

 

[DavidD]

Re: 90 Evinrude 115 powerpack

Thank you Bob!!! Never knew this existed!!!

 

[175se]

Re: 90 Evinrude 115 powerpack

ive seen two and both weren't firing #4

 

[boobie]

Re: 90 Evinrude 115 powerpack

Switch the coil with a good cylinder once and see what happens. Also a Model# would Help!!

 

[DavidD]

Re: 90 Evinrude 115 powerpack

I have swapped the other 3 to this position and none will fire. it is the top port cylinder have also swapped plugs as well. J115TSLEUA

 

[boobie]

Re: 90 Evinrude 115 powerpack

Read post# 2 again and check with them. I'd have to guess a bad power pack. JMHO.

 

[Bob_VT]

Re: 90 Evinrude 115 powerpack

Power packs here........ I am partial to the CDI ones Evinrude Power Packs

 

[Faztbullet]

Re: 90 Evinrude 115 powerpack

Well first your motor is a 97 model and has the single pack. These are very bad about dropping cylinders due to being damaged by inductive kick back from coil to switchbox. Replace the wires with the new grey suppressive wires(CDI) and replace thatt coil on that cylinder if you remember which one it is.

 

[johnson89]

Re: 90 Evinrude 115 powerpack

yes I had a bad coil,that messed up a powerpack ,would only fire on 3 cyl.s,,,,replaced all 4 coils and a new powerpack