Aluminum transom has had heat distortion

[Seasons Recreational]

I’m hoping to circumventdiscussion about whether pontoons or float pods are effective, and I have a problem.

I bought float pods from Beaver tails and had a local welder weld them onto the transom. The process of doing so completely distorted the transom. He’s willing to bang it back in the shape, but it’ll never be straight as it was. Are there any suggestions as to what is the best course at this point? Should I have him try to bang it back in the place? Should I replace the top section of the transom above the float pods? There’s some distortion below the float pods, but it’s minimal and I think it would be OK to leave. But I really need the upper section to be straight so that once the Coosa board transom is in, I can apply the cap over the top.

Any suggestions from the pros would be greatly appreciated! Thank you so much.

Adrian

 

[MikeSchinlaub]

Wow, I hope you didn't pay for that. The welds are good, but he should have known not to just do it in one long weld.

I don't know, that's a lot of warp to try to hammer out.

 

[Seasons Recreational]

Wow, I hope you didn't pay for that. The welds are good, but he should have known not to just do it in one long weld.

I don't know, that's a lot of warp to try to hammer out.

I will not disclose whether I paid for it or not, but I guess that answers the question for you!

I'm not a welder, but I think they do look good. He did say that he was going only about 4" at at time, but you're right, as soon as he got some deformation he should have stopped.

The good thing is that he is on-board to try to fix it, but I am just not sure what the best fix is. Aluminum does get work-hardening, so I am worried that it might be brittle. The transom has a flange all around that rivets to the gunnel. I was thinking if he cut the material out about an inch or 1 1/2" from the edge of the transom, and if he provides me a new sheet, I can maybe run a ton of rivets from the new transom to the flange, using 5200 to seal the two.

Last think I want is the transom to break loose in the middle of the lake!

 

[Scott Danforth]

Should have had a backer in the boat, like a sacrificial chunk of wood to help control warping also, in addition to a heat putty, should have stitched it 1/2" at a time, jumped 12" rinse and repeat. 4" is too long on thin sheet metal. also, the fillets are for 1/4" plate, so there is way too much heat.