Anybody have a Rinda 94006 (ECM 555) adapter and an ohm meter handy?

[undercover]

I bought a used rinda diacom cable, but it didn't come with the ECM/PCM 555 adapter - just the MEFI adapter. I'm going to order one, but I'm in a hurry to read my trouble codes (got the 2 beeps/min) tomorrow. I'm planning on making a temporary jumper but want to make sure the mapping I have from the 4-pin DLC connector to the 6-pin rinda connector is correct.

Here's what I think it is:



Thanks!

 

[bb_aes]

Re: Anybody have a Rinda 94006 (ECM 555) adapter and an ohm meter handy?

Did you find out if your wiring was correct? I just bought the tool also and need that adapter (but did not know to order it when I bought the tool). I'd rather make it up myself if you can confirm the wiring. Thanks for posting!

 

[undercover]

Re: Anybody have a Rinda 94006 (ECM 555) adapter and an ohm meter handy?

Swap the two data lines, and what I had was correct. But, for some reason, the software wouldn't recognize my make-shift adapter and connect with the ecm. It must not be straight-thru wiring. I got the adapter from rinda and connected right away.