Anyone know what shaft length this is? (picture attached)

[datoshway]

I can't tell what shaft length this is. A little help?

 

[Whoopbass]

Re: Anyone know what shaft length this is? (picture attached)

short

 

[BonairII]

Re: Anyone know what shaft length this is? (picture attached)

Looks like a long shaft to me.

 

[Texasmark]

Re: Anyone know what shaft length this is? (picture attached)

You are probably running a 10" prop on that engine. So, scaling off that in your pic looks like 20"....pretty long for a 15.

Mark

 

[Whoopbass]

Re: Anyone know what shaft length this is? (picture attached)

If you have access to the motor then measure from the under the lower motor cover where the motor block bolts to the bottom to the bottom of the skeg. If its roughly 30"-31" its a short shaft 35"-36" its a long.

 

[Chinewalker]

Re: Anyone know what shaft length this is? (picture attached)

It is a short shaft (15-inch transom). The long shaft Johnrude 25/35 was significantly longer under the "horseshoe" at the base of the swivel bracket.

 

[bonz_d]

Re: Anyone know what shaft length this is? (picture attached)

I have basically the same engine, Evinrude, and yes that is a short shaft for a 15" transom.

 

[seahorse5]

Re: Anyone know what shaft length this is? (picture attached)

The model number will tell you.