Bevel Prop Washer

[alldodge]

Merc Flow Torque prop hub uses 3 washers and a self locking nut. The only one so far that isn't just a flat washer is the bevel (or conical) type. All dimensions are accurate except for maybe the Height. My caliper's jaw was not made so I could get to outer edge of each side. I should have layed it flat and used the depth to get it, but reinstalled and don't want to take it back off unless needed

So I'm looking to find where these can be obtained. The other flat washers will not need to be replaced, and with a Nut and washer kit 840383A2 cost of $50, I'm looking now to see what can be found

 

[Fun Times]

While I recall seeing a few beveled type washers here and there over the past years, at the moment finding a new one isn't ringing a bell yet but mostly wanted to mention that the Prop locks from Mcgard uses a beveled type washer that has to be installed a certain way out that may work out for what you're wanting to achieve.

Is this washer on your/a bravo drive or something older, etc.?

MerCruiser Prop Thrust Washers - MerCstuff.Com

On-Line Catalog Page 01 : MerCstuff.Com

Propeller Locks – McGard

mcgard.com

 

[alldodge]

This is on my Verado's, note washer "d" orientation.
Have discovered the industry seems to call them spring and conical washers

 

[Scott Danforth]

that is a belleville spring washer. (We used them in actuator clutch packs). fastest way to get them is McMaster Carr

McMaster-Carr

McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.

www.mcmaster.com

 

[alldodge]

I've looked at McMaster and was unable to find one that meets spec