Blue Star Transom Corner Cap?

[Sharp1971]

I recently picked up a 14ft Blue Star Aluminum boat that I'm going to fix up...
I believe the boat is 1950-1960's
I'm hoping maybe someone can point me in a direction to find an aluminum Port-Side Corner Cap?
As you can see, this one has a nice homemade piece that I'd like to replace.

Due to the age of the boat, I'm not sure where to look, outside of eBay and Marketplace
Thanks.

 

[Scott Danforth]

Ebay, marketplace, and post in AOMCI

Other than that, make one

 

[DeepCMark58A]

Start scanning Craigs list in several states. I needed corner handles for my 57 Alumacraft scanned 4 states for 6 months found a donor boat in eastern WI

 

[tphoyt]

If push comes to shove you could look into have one 3D printed.

 

[Scott Danforth]

To 3D print that out of AlSi10Mg would require a good 3D scan or CAD model, and about $500

 

[redneck joe]

if restoring for function, make one otherwise keep looking at it may never happen but at least you can enjoy the hunt.

 

[Scott Danforth]

there are generic semi-tailored fabricated corner caps that are about $60 per side out there. they take some hammer and dolly work on some boats to get to fit, but that is an alternative.

since blue star went away over 6 decades ago, the chance of finding a corner cap is less likely than finding an honest politician.