chysler 105 wiring

[natedawg]

i just got this 1975 15.5 foot starcraft tri-hull with a chrysler 105. mod#1059he ser#12532 is this also a 1975? well i got this with a blown head gasket so i ordered a head gasket and an impeller kit my question is that when i got it all the coils are of of it so i have no idiea what coil goes to what cylinder. they are still hooked up to the coil wires i also ordered a manual for it but it will take a couple of weeks to get it in.

 

[eurolarva]

Re: chysler 105 wiring

Motor is a 1976. The firing order for that motor is 1-3-2-4. Because of the CD unit I am not sure how you are going to tell which coil goes to what cylinder. You might be able to find out what cylinder the rotor is firing by removing the distributer cover and work back from that unit to the coil.

 

[natedawg]

Re: chysler 105 wiring

ok thanks.

will check it out

Nate

 

[natedawg]

Re: chysler 105 wiring

Motor is a 1976. The firing order for that motor is 1-3-2-4. Because of the CD unit I am not sure how you are going to tell which coil goes to what cylinder. You might be able to find out what cylinder the rotor is firing by removing the distributer cover and work back from that unit to the coil.

Not sure where the distributor cover is this motor seems to not have one the coils are mounted to the head and just have a single wire coming out of the wiring harness going to each coil. They are different colors. Will I have to remove the fly wheel to get to the distributor...?

Thanks for the help

Nate

 

[natedawg]

Re: chysler 105 wiring

i have a few picks of the wiring and hope this will help if some one has a four cylinder that is the same year or close to it mabey they cole tell me what color wire goes to what cylinder,.....please help....

 

[natedawg]

Re: chysler 105 wiring

i have a few picks of the wiring and hope this will help if some one has a four cylinder that is the same year or close to it mabey they cole tell me what color wire goes to what cylinder,.....please help....i cant figure out how to attach them to this can some tell me how?

 

[rodbolt]

Re: chysler 105 wiring

not sure if it will help but i have service manual0b1565 that covers69 and later 70-150 chyslers. came with a 105 i am parting out.
model 1057he
anyway under the magnapower II section it shows the upper two coils with a black jumper on the positive primaries and the top coil - primary is the brown wire, 2nd coil is red/black going to its - coil primary.
the bottom two have black jumpers between their negative coil primaries and #3 coil has a orange brown to its positive primary and #4 has a yellow black going to its positive primary.

 

[eurolarva]

Re: chysler 105 wiring

Go here
http://www.themarinedoctor.com/cgi-bin/YaBB.pl/YaBB.pl
Post a question in his chrysler forum. He should be able to answer your question.

 

[natedawg]

Re: chysler 105 wiring

cool thanks guys that was what i am looking for they are all still hooked up just not bolted on all the wires are still on them and every thing had to buy a new piston and rings for one cylinder now i just found out that i need a gear in the lower unit the one on the bottom of the drive shaft.......

 

[natedawg]

Re: chysler 105 wiring

not sure if it will help but i have service manual0b1565 that covers69 and later 70-150 chyslers. came with a 105 i am parting out.
model 1057he
anyway under the magnapower II section it shows the upper two coils with a black jumper on the positive primaries and the top coil - primary is the brown wire, 2nd coil is red/black going to its - coil primary.
the bottom two have black jumpers between their negative coil primaries and #3 coil has a orange brown to its positive primary and #4 has a yellow black going to its positive primary.

would you happen to have the gear on the drive shaft? and if you do how much do you want for it?