Rebuilding my 2000 VX255 due to a loss of oil transfer. Clover Leaf at the bottom of the oil level assembly was curled badly on one side. Warning never went off. Still had 48oz in the remote tank. Whether or not the clover caused the oil to stop transferring, I'm not sure. I'll check it out when I get the wiring reconnected. I see there are lots of info or that here.
My question is, is the clover leaf replaceable itself or must you replace the whole Oil Level assembly? Doesn't look like a very good design or material selection. Is there a better material to maybe fabricate one from? Rodbolt, I believe I saw where you said the OX66 was the only one with this design?
My question is, is the clover leaf replaceable itself or must you replace the whole Oil Level assembly? Doesn't look like a very good design or material selection. Is there a better material to maybe fabricate one from? Rodbolt, I believe I saw where you said the OX66 was the only one with this design?