Control and Throttle cable replacement

[chefdecuisinedavid]

Looking for specs on throttle and control cables for a 2000 Larson Cabrio 330.
Need to replace them.
Only markings I could find where on the throttle cable attached

 

[alldodge]

Search Teleflex CC17222
Finding it's a series 3000 cable and last 2 digits is the length so 22ft

 

[chefdecuisinedavid]

Thanks, would finding that help me find the specs for the shift control cable as well?

 

[alldodge]

Thanks, would finding that help me find the specs for the shift control cable as well?

Yes, search Teleflex CC17222 specs

Here is pdf for cables
https://humcomarine.com/wp-content/uploads/06EngineControls/51-EngineConTeleflexControlCables.pdf

This is 3300 series
https://www.projectk.co.jp/marine/pdf/3300CC.pdf

 

[Scott Danforth]

you have to look at the shift cable to get its length.

 

[chefdecuisinedavid]

Rear deck removed

 

[Scott Danforth]

so now crawl back there and get the number off the shift cable.

or pull the drive, pull the zip tie, feed the cable out of the hose, pull the cable out from the starboard gunwale and measure it.

 

[chefdecuisinedavid]

Scott, I was told throttle and shift cables are the same.
Thank you

 

[Scott Danforth]

Scott, I was told throttle and shift cables are the same.
Thank you

On a VP, they are not

 

[ejnichol]

The new part # should be ccx17222. Your throttle cable is normally longer than i/o shifter cable.

 

[Scott Danforth]

On the shift cable shown, it exits the transom shield thru that hose, then goes another 2 feet to the shift assembly at the back of the drive.

The shift cable should be at least 2, maybe 3 feet longer in a VP than the throttle cable

On a Mercruiser with an upper cable and a lower cable, then the shift cable is slightly shorter or same length

 

[ejnichol]

Measure them laid out straight on flat surface on flat surface tip to tip if you have doubts or part # is illegible on one.

Depends on where the engine is in proximity to transom as to which is longer. Also how the installer routed cable through the obstacles going from shifter to throttle or outdrive cable attachment point.

Did a boat yesterday and throttle cable 1 ft longer than shifter due to u turn in cable routing for return to throttle body.