FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Most people wire them to any source that is powered when the "key" is on.
The only problem with that is if you leave the key on inadvertently, the hour meter will run until the battery goes dead.
You could get a normally open oil pressure switch that would connect power only when the engine is running but that's WAY over kill!!
Depending on where you mount the hour-meter, Just connect it to any power source that is on when the ignition is powered.
Many hour meters will operate as low as 6-7vdc ...... so you could also connect it directly to the coil + terminal if you mount it in the engine compartment.
The easiest way is to power it from the "Run" circuit of your ignition switch, the purple wire. But you MUST turn your key switch to off, or, as HT said, it will continue to rack up hours...
For an inboard it is best to install a pressure switch on the engine block. This way the hour meter is a true reading of actuall engine hrs. You may already have one on the engine. In this case you can tie into it for your hour meter.
