Didn't break anything

[old jim]

However, disconnected the fuel line at the tank. Holy crap batman what a mess the inside of the
fuel line. Started checking inside the engine. I could not find any particles of the plastic
liner in the filter or hose from the male connecter. So all new hose and bulb are installed. Need I look
further? old jim

 

[MH Hawker]

Re: Didn't break anything

I ran into the same thing recently, I was using the silver line stuff with one of the attwood fuel line kits, it has a thin liner inside , and mine was coming apart. if its running ok I would think its fine. In my case I am going to have to go through my carb , the idle mixture screw isn't working like it should. Its way to rich right now so some thing is about hafe plugged up.

 

[BatDaddy1887]

Re: Didn't break anything

.....it could have been the affects of ethanol gas on old rubber. It's a good thing you changed out all the lines, now you may want to rebuild your fuel pump...it's just a few bits of new rubber and a spring...very easy job. Use a half-a-can of Seafoam every few tankfuls to keep it all clean in there and you are good to go!