Does This Sound Right? Bravo Install

[Kola16]

I replaced my old MC-1 drive with a used Bravo drive assembly. I installed a new gimbal bearing, U-joints, and drive oil in the new drive assembly. Did the alignment, which maybe that could have been better, but I could pull the bar out with 2 fingers (barely?) and spin the bar without any grinding.

Does this sound normal? Sounds clunky to me. Roughly 900 RPMs.

 

[Fun Times]

No, doesn't sound right... maybe try pulling the drive off and see if the noise goes away/changes....But be sure to add water to the intake water hose location at the gimbal bell housing before starting the engine...The idea,

Also try using something like a broom handle, stick, etc. to place around the engine and drive areas to help listen for a more definite sound location.