Driveshaft housing oil seals and driver tool help

[TheRussian]

Good day,

I am in the process of resealing an Alpha One Gen 2 outdrive. The current drive has 2 separate oil seals around the driveshaft. The seal kit in my possession has a single, thicker seal with the lip (spring) on both sides. I am OK to use the single seal instead of 2 separate seals? It seams reasonable to me but I want to double check.

Also, the driver tool for these seals is quite expensive (91-817570). Does anyone have a workaround?

Thanks!

 

[Scott06]

Good day,

I am in the process of resealing an Alpha One Gen 2 outdrive. The current drive has 2 separate oil seals around the driveshaft. The seal kit in my possession has a single, thicker seal with the lip (spring) on both sides. I am OK to use the single seal instead of 2 separate seals? It seams reasonable to me but I want to double check.

Also, the driver tool for these seals is quite expensive (91-817570). Does anyone have a workaround?

Thanks!

i bought a seal and bearing cup driver set from Harbor Freight worked great had an assortment of seal and bearing cup drivers.

look at parts diagram in this link there is a serial number split for one seal vs two- part #5. Would only assume that if the later siungel seal worked for all they would supercede it not offer 2 but maybe mercruiser tech support can confirm that

MerCruiser Alpha One (Gen. II) 1998 & Up Driveshaft Housing & Drive Gears Parts

MerCruiser alpha one (gen.ii) 1998 and up driveshaft housing and drive gears parts. Buy a genuine Mercury Quicksilver or aftermarket part.

www.marineengine.com

 

[TheRussian]

Thanks. I was hoping that a bearing driver would work.

Regarding the seals, my outdrive is 93/94 with 2 seals. It just appears that a single seal that has the lip with a spring on both sides would/should theoretically work, but I would like to confirm that.