outdoor _guy
Cadet
- Joined
- Mar 3, 2023
- Messages
- 8
1977 Johnson 140...
The motor will only start if I disconnect the fuel line to the engine feed for pump. It will run just fine. Do you think the float is out of adjustment? I have it adjusted to parallel with the gasket surface of the carburetor. Do you think I should adjust it so that it leans down a bit instead of parallel. Seems the needle may not be seating right? Going to look at it again tomorrow, but was looking for some kind of help. Not a boat mechanic, but am very handy and can work on vehicles.
Boat this boat not running and the guy didn't tell me what he has done to it. Ha e replaced a ton of stuff to finally get spark and check timing. At idle it is at 4° have it adjusted to 24° with throttle all the way open and spark plugs out.
The motor will only start if I disconnect the fuel line to the engine feed for pump. It will run just fine. Do you think the float is out of adjustment? I have it adjusted to parallel with the gasket surface of the carburetor. Do you think I should adjust it so that it leans down a bit instead of parallel. Seems the needle may not be seating right? Going to look at it again tomorrow, but was looking for some kind of help. Not a boat mechanic, but am very handy and can work on vehicles.
Boat this boat not running and the guy didn't tell me what he has done to it. Ha e replaced a ton of stuff to finally get spark and check timing. At idle it is at 4° have it adjusted to 24° with throttle all the way open and spark plugs out.