Finding a leak, any ideas

dleibman

Cadet
Joined
Jul 8, 2010
Messages
7
When I recently purchased my 32' Martinique I knew it had a couple of interior water leaks caused by rain. I have been able to find and seal all the leaks except one. It is located over the aft berth on the FLAT part of the overhead, not the slanted areas or by the window behind the berth. It appears to be the area just below the helm bench at the console where the flip up captain's seat is and it's base goes back a few inches. Any ideas or suggestion would be welcomed. By the way, at the console area mentioned it has worn sealent between the deck and bench seat base.:confused:
 

EWillie

Cadet
Joined
May 26, 2009
Messages
14
Re: Finding a leak, any ideas

Check all cup holder drains. I have had water draining into my aft cabin and it was following the drain line to the lowest point no where near the cup holder. Just a though.
 

GWiggins

Cadet
Joined
Aug 3, 2011
Messages
8
Re: Finding a leak, any ideas

Have the same leak problem did you find the culprit..
 

Hooked on Deanna

Petty Officer 2nd Class
Joined
Feb 22, 2009
Messages
142
Re: Finding a leak, any ideas

Check the arm rest clips...I had to re-seal my hold clips
 
Last edited:

GWiggins

Cadet
Joined
Aug 3, 2011
Messages
8
Re: Finding a leak, any ideas

Where are the arm rest clips and how do I get to them?
In the aft area I'm have leakage above the window as well as the flat area (ceiling) previous owner states he re rebeded the window.
Then in the hanging closet by the v berth leak also that I can't seem to solve..


Not the right area to post but has anyone with a 3200 martinque replaced the starboard fuel sending unit I can't figure out how to get the old one out and replace doesn't appear to be enough room when accessing from the engine compartment

Thanks for any help new boat for me and trying to figure her out still
 

Hooked on Deanna

Petty Officer 2nd Class
Joined
Feb 22, 2009
Messages
142
Re: Finding a leak, any ideas

I discovered a possible leak location being the windshield hold down screws. I had a leak at one of the topside ports. I removed the trim and saw where it was running in the topside deck cavity. The only way it could get there is from a breach of the topside shell - I check the only place a breach could be and discovered that I had a loose and unsealed screw.
 
Top