luvngspnful
Cadet
- Joined
- Jun 23, 2009
- Messages
- 17
This old motor hasn't been run for about 11 years or so. I tuned it up with a new impeller and plugs and fuel pump. It runs hi speed just dandy but doesn't want to idle slow enough for trolling. I took off the flywheel and reset the points which looked brand new to .02. anyone have any suggestions as to what would cause this idle problem.
It sputters getting slower, slower till it coughs and quits if I close down the rich/lean nob to below 3.
Are carb kits available for these?
Thanks for help guys, I appreciated it.
ps: I noticed the screen on the water intake on the lower unit is missing. Could the engine not be warming up enough because of this part missing?
I used 100% gas before mixing 50:1 ratio..(no alcohol additives etc)
It sputters getting slower, slower till it coughs and quits if I close down the rich/lean nob to below 3.
Are carb kits available for these?
Thanks for help guys, I appreciated it.
ps: I noticed the screen on the water intake on the lower unit is missing. Could the engine not be warming up enough because of this part missing?
I used 100% gas before mixing 50:1 ratio..(no alcohol additives etc)