honing cylinder wall

[chodie]

I have a scoured cylinder wall. It is too expensive to have it bored. Is it possible to hone out 30 thousands?

 

[rolmops]

Re: honing cylinder wall

Not likely.To get a perfect hone you must have the steadiness of an Olympic sharpshooter. This is clearly a case where going on the cheap will turn out to be the most expensive.

 

[Chinewalker]

Re: honing cylinder wall

I concur. Spend the $40-$50 bucks to have it bored correctly. Nothing like buying oversize pistons & rings, and new gaskets, only to have a ring catch a port or the pistons stick first time out. Cheap? I think not...
- Scott

 

[4.0l sahara]

Re: honing cylinder wall

You can't hone .30 over.:redface:

 

[Faztbullet]

Re: honing cylinder wall

If its the 99 6hp you have , junk it. The oil pump is not avaliable say's BRP site. I would not rebuild it unless I could replace pump. My $.02.........

 

[ezeke]

Re: honing cylinder wall

Are we talking about the 9.5 HP?

 

[chodie]

Re: honing cylinder wall

I'm talking about the 99 6 hp. model. I don't know much about engines. Does it have an oil pump?

 

[ezeke]

Re: honing cylinder wall

If it is a 2 stroke, then no.

 

[BigNiner19]

Re: honing cylinder wall

I have a scoured cylinder wall. It is too expensive to have it bored. Is it possible to hone out 30 thousands?

I just had my cylinders bored out .030 on my 60HP. Came out really well...I blew up a piston and scuffed up one cylinder really bad, but all three cylinders were pretty worn out.

Cory

 

[Faztbullet]

Re: honing cylinder wall

Brp site shows 99 6 hp as 4 stroker.