i command gauges

[snap2]

i have a 2009 etec 130 hp with i-command gauges i have disconnected all power to the motor and gauges for a week now i have
connected it all back to power and now my gauges light up but no engine hours or any thing else when i turn the key on all help is needed
cheers snap

 

[dingbat]

i have a 2009 etec 130 hp with i-command gauges i have disconnected all power to the motor and gauges for a week now i have
connected it all back to power and now my gauges light up but no engine hours or any thing else when i turn the key on all help is needed
cheers snap

Hopefully you disconnected battery power before disconnecting everything else.
ECM don't like to be connected or disconnected while "hot"

 

[snap2]

Hopefully you disconnected battery power before disconnecting everything else.
ECM don't like to be connected or disconnected while "hot"

yes i did

 

[saltchuckmatt]

I had one but never experienced that. Use this link to go where everyone goes when you have an etec issue.

Report back later with any findings. Good luck

E-TEC V-4 - Barnacle Bill's Marine Supply

Post your 115 and 130hp questions here

www.etecownersgroup.com