Installing a Tow hitch

H20Rat

Vice Admiral
Joined
Mar 8, 2009
Messages
5,204
Re: Installing a Tow hitch

I don't think it is very wise to weld anywhere on a bolt. You could be creating stess in the metal.

I've seen factory OEM hitches that come with these pre-installed... The nuts are almost always stronger than the bolts and rarely the failure points, and the heat required is minimal.
 

Tom P

Petty Officer 2nd Class
Joined
Oct 1, 2006
Messages
140
Re: Installing a Tow hitch

Thanks - All
I ordered a Curt trailer hitch with lighting and a trans cooler. Just a though . . . I'm the 3rd owner of this 1999 jeep with 210.000 miles on it, It's in great condition. Runs like a top. Cleaner than my last one was with half the milage. I'm thinking it might be a good idea to change the transmission fluid while putting in the cooler. What does it take to change the trans fluid? Is it more complex than chaning the oil?

Thanks,

Tom
 

JimMH

Petty Officer 1st Class
Joined
Sep 4, 2009
Messages
361
Re: Installing a Tow hitch

Depends on wheather or not it is a manual or automatic. If it is an automatic you will need to remove the pan and change the filter that will be exposed once the pan is off. You will also need to clean out the pan really good there will usually be some metal in the pan. Not a bad job but if you have someone with a lift it will be a heck of a lot easier.
 

surge006

Petty Officer 2nd Class
Joined
Sep 25, 2009
Messages
100
Re: Installing a Tow hitch

I've heard if the trans fluid has never been changed before you shouldnt change it do to the detergants in the new fluid will eat away at the already worn metals. Like i said i heard, no clue if its true or not maybe someone will bust this myth
 

NYBo

Admiral
Joined
Oct 23, 2008
Messages
7,107
Re: Installing a Tow hitch

I've heard if the trans fluid has never been changed before you shouldnt change it do to the detergants in the new fluid will eat away at the already worn metals. Like i said i heard, no clue if its true or not maybe someone will bust this myth
Untrue. Detergents don't eat metal.

It IS possible for a poorly-done flush to sweep particles into the valve body and clog small passages. However, I think the origin of the the myth about not changing fluid if it has never been done stems from instances when the transmission is starting to go and the owner changes the fluid, hoping it will fix the problem. The transmission then fails completely, and the owner attributes the failure to the fluid change, even though it would have failed anyway.
 
Top