Installing steel cable to drum and pulley steering system

Bdp35

Recruit
Thread starter
Joined
Oct 27, 2026
Messages
1
I am replacing the rope with 3/16” steel cable on my 15ft 1956 wooden boat.

Can I use my old pulleys with this cable?

Please see photo of the U groove measurement of one of the pulleys.

Any advice would be greatly appreciated.

Thanks!
Brian
 

Attachments

  • IMG_0157.jpeg
    IMG_0157.jpeg
    1.6 MB · Views: 9

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,330
Plastic coated steel cable is the standard for those systems. If you boat in salt water stainless steel cable is better. Make sure the pulleys are well secured to the hull. I think the cable needs to wrap on the drum from the bottom. If done the other way, the steering will be backward.

Usually, the HP of the engine would be less than 50HP, with those steering systems, or the motor could wobble port to starboard at speed.
 

airshot

Admiral
Joined
Jul 22, 2008
Messages
6,781
Bare steel cable would wear out those pullies quickly, but the plastic sheath will prevent that. As long as the cable is not a snug fit into the pulley your good to go. As mentioned, be sure the puppies and springs are well anchored !
 
Top