It ran without cooling for a minute-damage?

Old Gamefisher

Seaman
Thread starter
Joined
Apr 20, 2009
Messages
51
I was given a 1990 15 hp Gamefisher/Force motor that hadn't run in 10 years or so. After rebuilding the fuel pump and carb (which were full of sediment and corrosion), it started on the second pull. I shut it down immediately, then put thelower end in a deep bucket in water deep enough to cover the water intake. I fired it up again, and waited about a minute for water to come out of the water outlet. It did not, so I shut it down. What's the likelihood that the engine was damaged by lack of cooling?
 

Barnacle_Bill

Admiral
Joined
Feb 8, 2004
Messages
6,469
Re: It ran without cooling for a minute-damage?

That short of time shouldn't hurt the motor but you do need to change the impeller.
 

Old Gamefisher

Seaman
Thread starter
Joined
Apr 20, 2009
Messages
51
Re: It ran without cooling for a minute-damage?

Thanks, Bill. Yeah, the impeller's so old that the arms have taken a "set" to them so that they don't expand out to the wall of the pump on the wide side. Based on what I learned from the friendly peolple here, I expected to have to replace that. Also, there are some pits on the inside of the pump body, so I'll be replacing that, too. When I ran a stream of water up the water pipe (motor not running), some kind of plant matter became dislodged (or an insect nest - the motor was covered with mud dauber nests when I started this project), and a lot of water started flowing out the outlet, so at least I know that's clear now.
 

sailingwest

Seaman
Joined
May 13, 2007
Messages
68
Re: It ran without cooling for a minute-damage?

Hi gamefisher ,you can run the engine safely with hose attached to pick up pipe just keep it at tickover.
 

Old Gamefisher

Seaman
Thread starter
Joined
Apr 20, 2009
Messages
51
Re: It ran without cooling for a minute-damage?

Thanks - it ran great today on the water (with a new impeller), so nothing catastrophic has happened.
 
Top