Looking for hardware source.

DRIFTER_016

DRIFTER_016

Petty Officer 1st Class
Thread starter
Joined
May 5, 2008
Messages
360
I'm looking for a source of solid stainless finishing washers.
I don't want the stamped ones as they will cut the vinyl that I'm covering my new helm trim panel with. The ones I'm looking for are flat on the backside and countersunk on the face.
The only solid finishing washers I have found so far are made of brass not stainless. :(

Thanks in advance.
 
F

fishrdan

Admiral
Joined
Jan 25, 2008
Messages
6,989
Re: Looking for hardware source.

I know what your talking about with the washers cutting into vinyl.

I took SS flat washers, then put a countersunk (whatever they are called) washer on top. The flat washer keeps the sharp finish washer from digging into the vinyl and you don't notice the flat washer,,, unless you look closely. Well at least that's the way it was on my padded panels :rolleyes:
 
You must log in or register to reply here.
Top