I think I have a bad lower shift cable, it will not go into either gear. it just clicks and then starts to give throttle before it locks in to gear. I tried to adjust the cable and it is hard to move by hand (stiff cable) and even when pulling cable out as far as it will go I can still turn the prop it just clicks.
so I am assuming it is bad , and if it is how hard is it to replace. Ive never taken an outdrive off and not sure If I can handle this job. I read the procedure, it sounds like it is difficult but not sure. do I need any special tools?? Or Is this I job best left to a pro??
thanks any help is appreciated
Nick
so I am assuming it is bad , and if it is how hard is it to replace. Ive never taken an outdrive off and not sure If I can handle this job. I read the procedure, it sounds like it is difficult but not sure. do I need any special tools?? Or Is this I job best left to a pro??
thanks any help is appreciated
Nick