Lube control cables

[RTZ]

Can I lube the control cables on my evinrude outboard using a compressor by just removing them from the forward controller and leave them attached to the engine? I do not want to remove them completely incase they get out of adjustment.

 

[racerone]

These factory cables are normally sealed and require no attention.-----Just curious why you ask the question.

 

[RTZ]

They seem to be getting a bit harder to move and I have heard you can oil them using compressed air to make them move easier.

 

[racerone]

Disconnect them at the motor.-----Operate the control box.-----Is it smooth.----And the motor must be running or propshaft must be turned when shifting your motor.

 

[oldboat1]

Add that the control box must be operating smoothly. If in fact the cables are binding, it's a safety issue and they need to be replaced.