Mariner Outboard Stalls when put in gear.

huffdiddys

Recruit
Joined
Apr 26, 2011
Messages
4
Hello,

I just bought my first boat. I have taken boat out 3 times now. Everytime its been a pain boating. The boat is a 21' 79 Steury Cuddy Cabin with a 115 hp mariner outboard motor. A little History so far.

I have replaced fuel pump gaskets and diaphram, primer ball and fuel line from motor to tank, new spark plugs, 2 new batteries one marine cranking and one marine deep cycle with all electronics and lights hooked too. Checked cylinder compression. Compression is within limits. Checked ignition coil. checks out good. Replaced wires that were weathered and cracked. Checked for fuel leaks up to the carbs no leaks.

This is what is going on.
I can start engine with muffs or in test tank or in the water. When cold i can drop down off fast idle to neutral and will idle fine. Seems the motor runs a little rough but have nothing to compare to. When operating on muffs it will start, idle, will go in forward gear, reverse gear just fine. As soon as it is in test tank or in lake the motor will start idle is not so good. sometimes when cold i can put in gear and it will be fine. Then ill drive in wot and motor runs good nice a smooth lots of power as soon as i back off of wot and try to put it back into nuetral motor will stall. It will start back up in fast idle but then i fight to get the boat motor to go again. Have to put it in fast idle and drop down to nuetral and put in forward get real fast and if im lucky motor wont stall. but 90 % of the time it stalls. Ive tried to adjust idle mixture screws per manual but no difference. I have not pulled carbs yet. I have been a auto mechanic for dealerships but never had to work on carbs. I suck with anything to do with carbs. I have no knowlege on them.
I am getting frustrated with this motor and want to get it running like it should. So any help will be great.
 

Wingedwheel

Lieutenant Junior Grade
Joined
Jun 16, 2009
Messages
1,071
Re: Mariner Outboard Stalls when put in gear.

The carbs are actually pretty easy, just do them one at a time and when you get to the last one you will be amazed. First thing to do though is get yourself a manual.
 

Barnacle_Bill

Admiral
Joined
Feb 8, 2004
Messages
6,469
Re: Mariner Outboard Stalls when put in gear.

Yes the carbs are easy to work on. Be sure to use new gaskets, needle and seats when re-assembling.
 

huffdiddys

Recruit
Joined
Apr 26, 2011
Messages
4
Re: Mariner Outboard Stalls when put in gear.

I figured it out. The idle stop screw wasnt tight and was idling below specs. Set idle in range and runs perfect now. thank you for the replies.
 

Wingedwheel

Lieutenant Junior Grade
Joined
Jun 16, 2009
Messages
1,071
Re: Mariner Outboard Stalls when put in gear.

So the motor no longer stalls?. Sometimes its something very simple. Welcome to boating.
 

huffdiddys

Recruit
Joined
Apr 26, 2011
Messages
4
Re: Mariner Outboard Stalls when put in gear.

Will find out this weekend the true results but so far in test tank is running good. I hope it checks out good. Ready to take it on lake michigan. Want to make sure she's fixed.
 
Top