rookiedave
Cadet
- Joined
- May 26, 2010
- Messages
- 20
Hi,
Just put my 2nd impeller in today. (cooked the first one) This time it went in so much better. I fired it up and it ran great. A little smokie but it sounded very strong and ran a long time 10 min before I shut it down. I ran it at idle and at fast rmp. it did not even skip one time. Took the cover off and touched the "block" a little warm but not scalding. Only question is the pee hole does not have more than a trickle of water coming out of it. This time I know, that the impeller is installed correctly. What should I do next?
Thankx
dave
I think that water first squirted out tell tail and then began to trickle.
Just put my 2nd impeller in today. (cooked the first one) This time it went in so much better. I fired it up and it ran great. A little smokie but it sounded very strong and ran a long time 10 min before I shut it down. I ran it at idle and at fast rmp. it did not even skip one time. Took the cover off and touched the "block" a little warm but not scalding. Only question is the pee hole does not have more than a trickle of water coming out of it. This time I know, that the impeller is installed correctly. What should I do next?
Thankx
dave
I think that water first squirted out tell tail and then began to trickle.