Merc 9.9 two-stroke; electric control cable pin question

[onepyramid]

I have my motor off the pontoon boat and want to start it to see that all is well before re-installing. Since this motor is normally controlled from the key switch on my helm, I assume I will have to jump between a couple of the pins in my control wire connector to activate the circuit and allow it to start.

The connector for the controls is an eight-pin type...see attached. Can someone tell me which pins need to have the jumper to make this work?

Thanks, in advance, for your help.

Mark

 

[racerone]

See if it has spark the way it is.------I think it will run.-----May need to use choke to stop it or run it out of fuel.