new to me 95 Celebrity 190BR

I

Indianaboating

Cadet
Joined
Feb 25, 2013
Messages
11
I have searched the forum and browsed a bit, I bought a 1995 Celebrity status 190BR 4.3LX a little over a week ago and I bought it knowing I would have to rebuild the motor, I have been trying to find what outdrive I have and finally found some light stamping on the serial plate 0F5743, I have looked on several sites and the puzzling thing is the 5.7 outdrives start with a 0F and the 4.3LX starts with a F. Just want to make sure I get the proper water impeller and bellows kit before I start tearing it all apart. Thanks for any and all replies! ;)
 
I

Indianaboating

Cadet
Joined
Feb 25, 2013
Messages
11
Re: new to me 95 Celebrity 190BR

Yes, it looks like that! Thanks for the help! I also cannot find a bellows kit with a exhaust tube. I take it I will have to order one seperately since I want to go the route with the tube? Thanks again!;)
 
I

Indianaboating

Cadet
Joined
Feb 25, 2013
Messages
11
Re: new to me 95 Celebrity 190BR

Thanks for the replies! I am getting ready to place a order and I had a question on the impeller and gasket sets, some sets look to have more o rings and gaskets and others have a housing with them, would it be wise to purchase the "repair" impeller set? I do not have my lower seperated yet because I don't want to get it all tore apart and just sit and just sit in pieces waiting for parts (I like to do a project all in the same day makes it easier remembering where everything went! :laugh:) I am just trying to get everything I need I am also picking up a new trim sender set while I am doing the bellows and since the engine is pulled I figured it would be a good time, The shift cable looks like it is relatively new I was debating on doing it as well. Just was kind of curious on the impeller choices.
 
You must log in or register to reply here.
Top