LastCall1983
Seaman
- Joined
- Jun 25, 2013
- Messages
- 55
I ordered a lower for my MC-1 outdrive and when i received it in the back stud was laying in the box, sheared off below the housing.
The only two options i can think of is have it taken to a shop and drilled, and backed out (i definitely don't trust myself to do it. Is it a possibility that a machine shop would damage the housing (break it off)? Or is there enough metal here that it wouldn't be much of an issue for them to back it out?
2nd option is run it without that back stud. Is this an option? I'd say NO but there are two studs in front if it pretty close and I'm just not sure.
Anyone else had this issue?


The only two options i can think of is have it taken to a shop and drilled, and backed out (i definitely don't trust myself to do it. Is it a possibility that a machine shop would damage the housing (break it off)? Or is there enough metal here that it wouldn't be much of an issue for them to back it out?
2nd option is run it without that back stud. Is this an option? I'd say NO but there are two studs in front if it pretty close and I'm just not sure.
Anyone else had this issue?

