q-jet linkage issue

[biddle1950]

'85 bayliner 1950 capri
350 omc stringer

the linkage on the starboard side seems to be stopping throttle linkage. there is a spot where the secondaries will open, but when it warms up, it's like it goes too far and stops the travel again. I watched many times and cant figure it out.

It seems like it is there to keep the secondaries from opening on a cold motor.

Some jeep guys say to remove the part.

also I replaced the carb to intake gasket with one thicker than the one that came off for fear of sucking air.

anyone else had this problem?

thank you.

 

[cr2k]

Re: q-jet linkage issue

This is a MARINE carb right? if not no answer from a lot of ppl due to liability.

Pictures will help a lot, as there are several linkages on this carb.

 

[Aloysius]

Re: q-jet linkage issue

The linkage for the secondaries is on the port side. There are usually linkages for the air valve on the starboard side.

Quadrajets should use a 1/2" thick base gasket..comes in the jiffy kits during a rebuild.

 

[biddle1950]

Re: q-jet linkage issue

Yes it is a marine carb. original to the boat.

the linkage is on the side with the choke spring.